| Subject | Text |
| Service Modes | Manufacturer Model Chassis Product Mode Enter
Akai CT-2119 CTV Test Mode
Simultaneous press + & |
| Need Eizo L66 Flexscan Monitor Service Manual | Hi Friends,
I need the sevice manual of the Eizo L66 TFT monitor. Kan someone send it to me or just |
|
|
| Help with Packard Bell Monitor 1024S | I have a KTX model M 1438 monitor. The FCC ID (DK4M1448) says it is a Packard Bell , model 1024S. I |
| Sony KP-41S4 projection tv with convergence problem | The former owner replaced the picture tubes, introducing a convergence error for red and blue. After |
| tv | [quote="drum"]sorry for the lack of info its a Sony TV is ther any war to make a recall or deguise ( |
| Hmmm. This could be a pain in the arse, but maybe not. It is possible that there is a missing low vo |
| measuring high value resistor? | i have a 1.8 Mega Ohm resitor, my meter can read up to 2 mega ohm, but when i try and read the value |
| Shorted transistor | This is almost textbook shorted transistor. I have had a denon that whe nI removed the output transi |
| What kind of multimeter do you use to measure the secondary voltage? Remember that many cheap digita |
| Home - Hilltech Sales Corporation | Hill Technical Sales provides quality component solutions for Power Conversion, Thermal, EMC, and UV |
| error 4 | from manual
Error 4 - checksum does not agree with reference checksum in NV memory during the last |
| I'd like to try and repair on my own if possible. Where can I get schematics on this unit? Didn't |
| Minnie; i really wonder what's the issue here. I've tapped HARDER on the neck of the crt with a rubb |
| And it just may help if you mentioned the make and model of the phone as well. |
| ti86 horizontal lines in the display | mine did it and here is the fix,
the problem was caused by the foil shielding inside the calculat |
| nissan qashqai radio code | Hello
Can someone decode radio code from my qashqai?
There are all information form the body of r |
| the connector is loose, once i plug it in to the cam and hold on to it (the connector), it seems fin |
|
|
| Hi,
The situation is very much the same here (in Bulgaria) - same new stores, which give credit, |
| Wher to find....... | I can't seem to find the mini plug I'm looking for..... :?
I need a Right angle mono 3.5mm jack |
| Jason,
When you say you disconnected the U board, did you get any raster?
I wonder why you wou |
| VIEWSONIC MONITOR (VE710B) | I have a unit that has had the 15 pin connector cut off (otherwise fully serviceable unit I believe) |
| dont forget to change low ohm resistor off flybackthat feeds the voltage usually 26volts to the vert |
| Hi Ed,
I had a similar situation with a '70's Pioneer amp using similar NEC transistors. Over her |
| Glad to see that you have finally seen the light :)
Actually, if you investigate further on the P |
| Re: SOLUTION | [quote:132451ae46="hajnrih"]OK. Its an amd turion laptop with a sis chipset. There is nothing wrong |
| While you may have a calibration issue, I've never seen a problem in measuring resistors in general |
| Re: Onkyo TX-NR609 no sound | [quote:e847d64572="Dire Wolf"]My Onkyo TX-NR609 was working without a problem when switched off. Whe |
| Philips TV 27PT5441/37 | I have answers to your blown fuse problems, click on the original
complaint date for answers or |
| For model SLPG370A the optical system is CDM12.1/0 , and fot SLPG400A - CDM4/19. It is more likely t |
| [quote:c32e7b74c6="vtech"]Ok, out of the 17 pins on the cable, eleven pins are used for different v |